Thingiverse
Test_Leveling
by Ron07
1
Downloads
1
Likes
0
Makes
Test to find best slicer - config
Print first 30x30x0.2mm (is first layer only by layer-high = 0.2mm) until this is fine.
And only then print 20x20x5mm for check height, width, depth and perfect corners.
And last find the perfect surface for your needs.
Print first 30x30x0.2mm (is first layer only by layer-high = 0.2mm) until this is fine.
And only then print 20x20x5mm for check height, width, depth and perfect corners.
And last find the perfect surface for your needs.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!