Thingiverse
TH3D Solid Mount Camera Arm Offset Adapter
von tophattwaffle
17
Downloads
10
Likes
1
Makes
This is a solid mount camera arm add-on to offset the camera from the normal position. This is good for printers with a re-enforced frame that cannot have the arm at a 45 degree angle from the front right standoff.
Expect some bounce on the camera as your bed moves.
Change Log:
9/2/2018
-Changed 2 side prong width from 4.8mm to 4.7mm.
-Adjusted nut height from 5.33mm to 5.6mm
Expect some bounce on the camera as your bed moves.
Change Log:
9/2/2018
-Changed 2 side prong width from 4.8mm to 4.7mm.
-Adjusted nut height from 5.33mm to 5.6mm
tophattwaffle veröffentlicht auch auf
2 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
