Thingiverse
TH3D Solid Mount Camera Arm Offset Adapter
door tophattwaffle
17
Downloads
10
Likes
1
Makes
This is a solid mount camera arm add-on to offset the camera from the normal position. This is good for printers with a re-enforced frame that cannot have the arm at a 45 degree angle from the front right standoff.
Expect some bounce on the camera as your bed moves.
Change Log:
9/2/2018
-Changed 2 side prong width from 4.8mm to 4.7mm.
-Adjusted nut height from 5.33mm to 5.6mm
Expect some bounce on the camera as your bed moves.
Change Log:
9/2/2018
-Changed 2 side prong width from 4.8mm to 4.7mm.
-Adjusted nut height from 5.33mm to 5.6mm
tophattwaffle publiceert ook op
2 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
