MakerWorld
Electronics
Ver Modelo
Thread Board Controller Stand
49
Descargas
28
Likes
15
Makes
I recently printed a thread board for my wall and wanted a solution for it to hold my controllers. I designed this universal controller stand to be used with (most) controllers. To mount these I used the Thread Board screws “HD12xSH10xTHR7”. I squeezed them into my print in the two holes and then screwed them into the thread board at the same time. I designed it this way so that the brack shows a little as possible.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
