MakerWorld
Electronics
Model downloaden
Thread Board Controller Stand
49
Downloads
28
Likes
15
Makes
I recently printed a thread board for my wall and wanted a solution for it to hold my controllers. I designed this universal controller stand to be used with (most) controllers. To mount these I used the Thread Board screws “HD12xSH10xTHR7”. I squeezed them into my print in the two holes and then screwed them into the thread board at the same time. I designed it this way so that the brack shows a little as possible.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
