Thread spool

von MChoate · Other Hobby & DIY

128 Downloads

27 Likes

78 Makes

Print in place thread spool designed for rod builders and other hobbyists. I got tired of the small amount of thread I could replace on the spools, so I created one that allows for much more. It prints as 2 separate pieces that fit together and use superglue to hold together. It is the same dimensions as a typical spool of prowrap however the interior cylinder is much smaller, so it will fit into thread carriages seamlessly.

rod building thread spool upholstery sewing sewing accesories thread 1022 thread accessories print in place

Kategorie

Other Hobby & DIY

Quelle

MakerWorld

Veröffentlicht

14.06.2025

Aktualisiert

30.04.2026

Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz

Warum?

Print-in-place-Design

Print-in-place

Supports 1/3

Zusammenbau 0/3

Einstellungen 1/3

Druckbett 0/3

Nachbearbeitung 0/3

Drucker

FDM / FFF

Dateiformat

STL

Material

PLA

Software

Cura, PrusaSlicer o. Ä.

Noch keine Bewertungen

Noch keine Kommentare – sei der Erste!

Thread spool

Ähnliche Modelle

Zur Sammlung hinzufügen