MakerWorld
Other Hobby & DIY
Go to Model
Thread spool
128
Downloads
27
Likes
78
Makes
Print in place thread spool designed for rod builders and other hobbyists. I got tired of the small amount of thread I could replace on the spools, so I created one that allows for much more. It prints as 2 separate pieces that fit together and use superglue to hold together. It is the same dimensions as a typical spool of prowrap however the interior cylinder is much smaller, so it will fit into thread carriages seamlessly.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
