Tiny MAC (Raspberry Pi inside)

This is nothing new, just another Raspberry pi emulation classic mac.

Print support needed even I have drawn some of the support.

This case is tight fit, it need your patient to cut the square holes and drill the earphone jack hole to fit for the pi.

I print it with 0.1mm layer, it takes 16 hrs to finish the case;less than 2 hrs to finish the bottom.

1 x M2.6 screw to mount the pi.
4 x M3 screw to mount the bottom to the case.
1 x 2.8" spi TFT LCD panel
1 x raspberry pi model 2 B with the SD card.