MakerWorld
Decor
Ver Modelo
Tiny Tea Light
2
Descargas
1
Likes
1
Makes
Tiny Tea Light Prints in under 30 minutes and requires no supports. Instructions (Please Read!) The magnet will fit snugly into the two halves of the match. Glue the parts together at the handle section. To loosen the match initially, pull it out from the bottom with pliers once or twice. After that, it should slide out easily by hand. No supports are required for printing. Since the magnet sits close to the light at the bottom, accidental switching on or off may occur.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
