MakerWorld
Decor
Voir le modèle
Tiny Tea Light
2
Téléchargements
1
Likes
1
Makes
Tiny Tea Light Prints in under 30 minutes and requires no supports. Instructions (Please Read!) The magnet will fit snugly into the two halves of the match. Glue the parts together at the handle section. To loosen the match initially, pull it out from the bottom with pliers once or twice. After that, it should slide out easily by hand. No supports are required for printing. Since the magnet sits close to the light at the bottom, accidental switching on or off may occur.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
