Thingiverse
Tiny Tower
por armedgeek
1
Descargas
1
Likes
0
Makes
When printing with fine (0.25mm and smaller) nozzles, scaling down a regular temp tower just doesn't cut it.
I've improvised this tiny tower with two things in mind: horizontal resolution and simplicity.
The walls don't have any holes; if you have stringing, it would be evident elsewhere. Decks have 45 degree negative slants for ease of reading the "scribble" on a deck below. Deck spacing is consistent, it's 5mm all the way. Oh, and a "washer" at the base provides stability and adhesion.
That's all there is to it, enjoy!
I've improvised this tiny tower with two things in mind: horizontal resolution and simplicity.
The walls don't have any holes; if you have stringing, it would be evident elsewhere. Decks have 45 degree negative slants for ease of reading the "scribble" on a deck below. Deck spacing is consistent, it's 5mm all the way. Oh, and a "washer" at the base provides stability and adhesion.
That's all there is to it, enjoy!
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!