Thingiverse
Tiny Tower
door armedgeek
1
Downloads
1
Likes
0
Makes
When printing with fine (0.25mm and smaller) nozzles, scaling down a regular temp tower just doesn't cut it.
I've improvised this tiny tower with two things in mind: horizontal resolution and simplicity.
The walls don't have any holes; if you have stringing, it would be evident elsewhere. Decks have 45 degree negative slants for ease of reading the "scribble" on a deck below. Deck spacing is consistent, it's 5mm all the way. Oh, and a "washer" at the base provides stability and adhesion.
That's all there is to it, enjoy!
I've improvised this tiny tower with two things in mind: horizontal resolution and simplicity.
The walls don't have any holes; if you have stringing, it would be evident elsewhere. Decks have 45 degree negative slants for ease of reading the "scribble" on a deck below. Deck spacing is consistent, it's 5mm all the way. Oh, and a "washer" at the base provides stability and adhesion.
That's all there is to it, enjoy!
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!