Thingiverse
Top cover HyperCube Evolution
by zen-print
8
Downloads
4
Likes
0
Makes
# Top cover for HyperCube Evolution
A simple post with mounts that fit into 3030 aluminium extrusions (its a very firm fit; some force required). Printed 4 times it allows to build a top cover e.g. for the HyperCube Evolution.
- Post height is 13cm
- Plexiglas with up to 3mm thickness can be used for the cover. (I used super cheap 2 mm plexiglas which causes the bends...)
- Screw holes are for M3 screws. They will thread themselves.
A simple post with mounts that fit into 3030 aluminium extrusions (its a very firm fit; some force required). Printed 4 times it allows to build a top cover e.g. for the HyperCube Evolution.
- Post height is 13cm
- Plexiglas with up to 3mm thickness can be used for the cover. (I used super cheap 2 mm plexiglas which causes the bends...)
- Screw holes are for M3 screws. They will thread themselves.
zen-print also publishes on
9 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
