Thingiverse
Top cover HyperCube Evolution
door zen-print
8
Downloads
4
Likes
0
Makes
# Top cover for HyperCube Evolution
A simple post with mounts that fit into 3030 aluminium extrusions (its a very firm fit; some force required). Printed 4 times it allows to build a top cover e.g. for the HyperCube Evolution.
- Post height is 13cm
- Plexiglas with up to 3mm thickness can be used for the cover. (I used super cheap 2 mm plexiglas which causes the bends...)
- Screw holes are for M3 screws. They will thread themselves.
A simple post with mounts that fit into 3030 aluminium extrusions (its a very firm fit; some force required). Printed 4 times it allows to build a top cover e.g. for the HyperCube Evolution.
- Post height is 13cm
- Plexiglas with up to 3mm thickness can be used for the cover. (I used super cheap 2 mm plexiglas which causes the bends...)
- Screw holes are for M3 screws. They will thread themselves.
zen-print publiceert ook op
9 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
