Slicer Discord
Translucency Test Model – Modelo 3D imprimible de MakerWorld MakerWorld
Test Models

Translucency Test Model

249 Descargas
24 Likes
139 Makes
Ver Modelo
Use this model to test translucent prints of solid objects.See the following companion post:https://forum.bambulab.com/t/how-to-print-with-translucent-filaments/128728Getting optimal results will depend on the layers fusing together and cooling slowing to allow for crystallization. This will optimize molecular arrangement and allow for greater translucency. The following should be a good starting point for non-Bambu filaments: Global Settingsset print speed to 20mm/sset layer height to 0.1mmprint without top or bottom layers, as well as without wallsset infill to 100%set infill to have a single directionuse a hot, smooth build plateuse the the largest nozzle possible that still satisfies your quality requirementsset all line widths to [nozzle width] * 0.9Filament Settingsset print speed to 20mm/sturn off all fansincrease the temperature as high as possible without burning or bubbling; for PETG this might be between 260 and 270Cset flow rate to 1.01make sure PETG has less than 15% humid
Categoría
Test Models
Fuente
MakerWorld
Publicado
Actualizado
Lo que necesitas para imprimir: Intermedio Baja confianza
Pieza única
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 1/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
PLA, PETG
Postprocesado
Lijado
Software
Cura, PrusaSlicer o similar
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

6 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección