Translucency Test Model

Use this model to test translucent prints of solid objects.See the following companion post:https://forum.bambulab.com/t/how-to-print-with-translucent-filaments/128728Getting optimal results will depend on the layers fusing together and cooling slowing to allow for crystallization. This will optimize molecular arrangement and allow for greater translucency. The following should be a good starting point for non-Bambu filaments: Global Settingsset print speed to 20mm/sset layer height to 0.1mmprint without top or bottom layers, as well as without wallsset infill to 100%set infill to have a single directionuse a hot, smooth build plateuse the the largest nozzle possible that still satisfies your quality requirementsset all line widths to [nozzle width] * 0.9Filament Settingsset print speed to 20mm/sturn off all fansincrease the temperature as high as possible without burning or bubbling; for PETG this might be between 260 and 270Cset flow rate to 1.01make sure PETG has less than 15% humid