Thingiverse
USB Patch
door KDMcM
4
Downloads
2
Likes
0
Makes
Like most folk using Arduino-powered 3D printers, having installed Octoprint on a Raspberry Pi and connected it, I was faced with the irritating problem of the USB port powering the printer. This is one solution.
Yes, there area already a hundred solutions, some using sticky tape, but I never liked the wheel. I think it's a silly shape and I enjoy reinventing it.
So, I cut my USB cable, soldered in a DIL 4-way switch and printed up a little project box.
I can now switch off the positive supply rail to my printer's USB port.
Yes, there area already a hundred solutions, some using sticky tape, but I never liked the wheel. I think it's a silly shape and I enjoy reinventing it.
So, I cut my USB cable, soldered in a DIL 4-way switch and printed up a little project box.
I can now switch off the positive supply rail to my printer's USB port.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
