Winch Switch panel

Printed switch panel for an in cab winch control. Switch holes are 1/2" and will accommodate the common 12mm switches. Wiring and switch selection are winch dependent, but I used a DPST toggle for the safety switch, and a DPDT momentary for the in/out control.

Switch panel prints in two pieces and will take some finagling to get to fit just right. Print the lettering up for the inlay piece (white,) and face down for the frame(grey.) The inner portions of the R, O, and A's will have to be scraped from the build plate and glued in place. I drilled the hole for the armed indicator light as I felt that should be an option thus it is not in the STL