Thingiverse
Winch Switch panel
door enderlmw
15
Downloads
15
Likes
0
Makes
Printed switch panel for an in cab winch control. Switch holes are 1/2" and will accommodate the common 12mm switches. Wiring and switch selection are winch dependent, but I used a DPST toggle for the safety switch, and a DPDT momentary for the in/out control.
Switch panel prints in two pieces and will take some finagling to get to fit just right. Print the lettering up for the inlay piece (white,) and face down for the frame(grey.) The inner portions of the R, O, and A's will have to be scraped from the build plate and glued in place. I drilled the hole for the armed indicator light as I felt that should be an option thus it is not in the STL
Switch panel prints in two pieces and will take some finagling to get to fit just right. Print the lettering up for the inlay piece (white,) and face down for the frame(grey.) The inner portions of the R, O, and A's will have to be scraped from the build plate and glued in place. I drilled the hole for the armed indicator light as I felt that should be an option thus it is not in the STL
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!