Thingiverse
Folger FT-5 Z Induction/BLTouch Sensor
by retnel
15
Downloads
7
Likes
0
Makes
This is a remix /Meshmixer of two uploads.
Run FT-5_Z-Bed_Gap.gcode from an SDCARD after you have preheated your bed an nozzle in order to set your gap. What I normally do is run FT-5_Z-Bed_Gap.gcode and put a piece of paper under the nozzle and let it set for 15 minutes after the first iteration.
After 15 minutes pull the SDCARD out and reinsert it to stop the print. Then run it again to set the gap. I do this before every print to get best results. My gap is normally set once I can get
Run FT-5_Z-Bed_Gap.gcode from an SDCARD after you have preheated your bed an nozzle in order to set your gap. What I normally do is run FT-5_Z-Bed_Gap.gcode and put a piece of paper under the nozzle and let it set for 15 minutes after the first iteration.
After 15 minutes pull the SDCARD out and reinsert it to stop the print. Then run it again to set the gap. I do this before every print to get best results. My gap is normally set once I can get
Sign in to leave a comment
Sign in