Thingiverse

A Fully Printable Microscope

von kwalus

3.1k Downloads

3k Likes

20 Makes

Zum Modell

Well almost, you still need to locate 4 lenses from some disposable cameras and a light source.

For the light source use an LED or mirror, whatever you have. I used a cheap LED wall light from Wal-Mart.

For the lenses, I went to a local photography shop and they were very kind to give me an entire bag full (Thank you Lens and Shutter! http://www.lensandshutter.com/). Since I had so many, I designed it to work with them all. There is a different optical tube that you have to print for the Fujifilm lenses (11.9mm outer diameter) vs. the Kodak lenses (13.2mm outer diameter). It should work with the following as I measured them all and will likely work with others as well:

(CAUTION there is a significant shock hazard if you plan to open a flash camera from the capacitor!)

Fujifilm QuickSnap Outdoor
Fujifilm QuickSnap Flash
Fujifilm Flash

Kodak FunSaver Flash
Kodak unaned
Kodak Max Outdoor

I will try to keep an updated list of potential online so

3D printing engineering Fully Printable Microscope Lab Laboratory learning magnification Microscope optics printable tools science tools Zoom 3D printing engineering Fully Printable Microscope Lab Laboratory learning magnification Microscope optics printable tools science tools Zoom 3D printing engineering Fully Printable Microscope Lab Laboratory learning magnification Microscope optics printable tools science tools Zoom

Quelle

Thingiverse

Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz

Einteilig

Supports 1/3

Zusammenbau 0/3

Einstellungen 1/3

Druckbett 0/3

Nachbearbeitung 0/3

Drucker

FDM / FFF

Dateiformat

STL

Material

PLA

Software

Cura, PrusaSlicer o. Ä.

Noch keine Bewertungen

Noch keine Kommentare – sei der Erste!

A Fully Printable Microscope

Ähnliche Modelle

Zur Sammlung hinzufügen