Thingiverse
Boost SUP Adapter
von jepjep7
4
Downloads
2
Likes
0
Makes
I created a sturdy SUP slide-in-adapter for the wonderful Boost Electric Fin!
As was done in the original, I drilled out the screw channels and it had a nice snug fit.
Disclaimer: This file is for testing only. That being said, it functioned well when I tested it with my Stand-up Paddle-board in the water. There was slight lateral motion. I printed at 100 percent infill with PLA and it was sturdy.
A clip is useful but maybe not necessary if you tie it well with a leash (see photo). However, a more customized clip could help secure the adapter better.
It is my hope that others will also post some functional remixes to try. Enjoy!
As was done in the original, I drilled out the screw channels and it had a nice snug fit.
Disclaimer: This file is for testing only. That being said, it functioned well when I tested it with my Stand-up Paddle-board in the water. There was slight lateral motion. I printed at 100 percent infill with PLA and it was sturdy.
A clip is useful but maybe not necessary if you tie it well with a leash (see photo). However, a more customized clip could help secure the adapter better.
It is my hope that others will also post some functional remixes to try. Enjoy!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!