Thingiverse
Boost SUP Adapter
por jepjep7
4
Descargas
2
Likes
0
Makes
I created a sturdy SUP slide-in-adapter for the wonderful Boost Electric Fin!
As was done in the original, I drilled out the screw channels and it had a nice snug fit.
Disclaimer: This file is for testing only. That being said, it functioned well when I tested it with my Stand-up Paddle-board in the water. There was slight lateral motion. I printed at 100 percent infill with PLA and it was sturdy.
A clip is useful but maybe not necessary if you tie it well with a leash (see photo). However, a more customized clip could help secure the adapter better.
It is my hope that others will also post some functional remixes to try. Enjoy!
As was done in the original, I drilled out the screw channels and it had a nice snug fit.
Disclaimer: This file is for testing only. That being said, it functioned well when I tested it with my Stand-up Paddle-board in the water. There was slight lateral motion. I printed at 100 percent infill with PLA and it was sturdy.
A clip is useful but maybe not necessary if you tie it well with a leash (see photo). However, a more customized clip could help secure the adapter better.
It is my hope that others will also post some functional remixes to try. Enjoy!
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!