Boost SUP Adapter

I created a sturdy SUP slide-in-adapter for the wonderful Boost Electric Fin!
As was done in the original, I drilled out the screw channels and it had a nice snug fit.

Disclaimer: This file is for testing only. That being said, it functioned well when I tested it with my Stand-up Paddle-board in the water. There was slight lateral motion. I printed at 100 percent infill with PLA and it was sturdy.

A clip is useful but maybe not necessary if you tie it well with a leash (see photo). However, a more customized clip could help secure the adapter better.

It is my hope that others will also post some functional remixes to try. Enjoy!