Thingiverse
Boost SUP Adapter
par jepjep7
4
Téléchargements
2
Likes
0
Makes
I created a sturdy SUP slide-in-adapter for the wonderful Boost Electric Fin!
As was done in the original, I drilled out the screw channels and it had a nice snug fit.
Disclaimer: This file is for testing only. That being said, it functioned well when I tested it with my Stand-up Paddle-board in the water. There was slight lateral motion. I printed at 100 percent infill with PLA and it was sturdy.
A clip is useful but maybe not necessary if you tie it well with a leash (see photo). However, a more customized clip could help secure the adapter better.
It is my hope that others will also post some functional remixes to try. Enjoy!
As was done in the original, I drilled out the screw channels and it had a nice snug fit.
Disclaimer: This file is for testing only. That being said, it functioned well when I tested it with my Stand-up Paddle-board in the water. There was slight lateral motion. I printed at 100 percent infill with PLA and it was sturdy.
A clip is useful but maybe not necessary if you tie it well with a leash (see photo). However, a more customized clip could help secure the adapter better.
It is my hope that others will also post some functional remixes to try. Enjoy!
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !