Slicer Discord
Drawer stackable boxes – 3D-Druckmodell von Thingiverse Thingiverse

Drawer stackable boxes

von ag-1
49 Downloads
137 Likes
0 Makes
Zum Modell
A lot of different type of boxes with magnet holes inside.
You should pause and place magnets in it (instructions below).

All boxes are made in a grid 50x50, so you can put them in a grid.
Almost all of them with double bottom.

This types are available (sizes given in a grid scope):
- SD card box (1x1)
- Pen box (4x2)
- Credit card box (2x1) `Card-box`
- Box with corner section (3x2) `medicine-box`
- Square box (2x2) `box-2x2`
- Small rectangle box (2x1) `box-2x1`
- Big rectangle box (3x2) `box-3x2`
- Flat box (1x1)
- Flat long box (2x1)
Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen