Slicer Discord
Drawer stackable boxes – Modelo 3D imprimible de Thingiverse Thingiverse

Drawer stackable boxes

por ag-1
49 Descargas
137 Likes
0 Makes
Ver Modelo
A lot of different type of boxes with magnet holes inside.
You should pause and place magnets in it (instructions below).

All boxes are made in a grid 50x50, so you can put them in a grid.
Almost all of them with double bottom.

This types are available (sizes given in a grid scope):
- SD card box (1x1)
- Pen box (4x2)
- Credit card box (2x1) `Card-box`
- Box with corner section (3x2) `medicine-box`
- Square box (2x2) `box-2x2`
- Small rectangle box (2x1) `box-2x1`
- Big rectangle box (3x2) `box-3x2`
- Flat box (1x1)
- Flat long box (2x1)
Fuente
Thingiverse
Lo que necesitas para imprimir: Intermedio Baja confianza
Pieza única Tornillería requerida
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 1/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
PLA
Postprocesado
Tornillería
Software
Cura, PrusaSlicer o similar
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

6 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección