Slicer Discord
Drawer stackable boxes – 3D-printbaar model van Thingiverse Thingiverse

Drawer stackable boxes

door ag-1
49 Downloads
137 Likes
0 Makes
Model downloaden
A lot of different type of boxes with magnet holes inside.
You should pause and place magnets in it (instructions below).

All boxes are made in a grid 50x50, so you can put them in a grid.
Almost all of them with double bottom.

This types are available (sizes given in a grid scope):
- SD card box (1x1)
- Pen box (4x2)
- Credit card box (2x1) `Card-box`
- Box with corner section (3x2) `medicine-box`
- Square box (2x2) `box-2x2`
- Small rectangle box (2x1) `box-2x1`
- Big rectangle box (3x2) `box-3x2`
- Flat box (1x1)
- Flat long box (2x1)
Bron
Thingiverse
Wat je nodig hebt om te printen: Gemiddeld Lage betrouwbaarheid
Eendelig Hardware nodig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 1/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA
Nabewerking
Hardware
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie