Thingiverse
easythreed k10 More Solid Base
por skybluetree
8
Descargas
28
Likes
0
Makes
Installation Guide
⚠️ Important: This part cannot be printed on the K10 printer itself.
1. Remove the Y-axis Plastic Cap.
Unscrew and remove the plastic cap on the Y-axis.
Make sure to detach the part on the side where the motor is located.
2. Disconnect the Mainboard and Wires.
Carefully detach the mainboard.
Disconnect the hotend wire and the X-axis motor wire, then pull them through to the side panel.
3. Tidy Up the Remaining Wires.
Neatly guide the Y-axis and Z-axis wires to the back of the printer.
⚠️ Important: This part cannot be printed on the K10 printer itself.
1. Remove the Y-axis Plastic Cap.
Unscrew and remove the plastic cap on the Y-axis.
Make sure to detach the part on the side where the motor is located.
2. Disconnect the Mainboard and Wires.
Carefully detach the mainboard.
Disconnect the hotend wire and the X-axis motor wire, then pull them through to the side panel.
3. Tidy Up the Remaining Wires.
Neatly guide the Y-axis and Z-axis wires to the back of the printer.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
