ESPixNode Case w/PG7
by PaulTKennedy
9
Downloads
5
Likes
0
Makes
Remixed from hitekstuff's design.
Added nubs to snap the board into.
Swapped orientation of mounting hole.
Added full enclosure and hole for PG7 gland—shared output for DC pigtail and JST-SM connector.
Added graphics to lid.
As shown in pictures, everything is a TIGHT fit—be very careful sliding the lid over the wires.
NOT WATERPROOF, just using the PG7 as a strain relief!
Added nubs to snap the board into.
Swapped orientation of mounting hole.
Added full enclosure and hole for PG7 gland—shared output for DC pigtail and JST-SM connector.
Added graphics to lid.
As shown in pictures, everything is a TIGHT fit—be very careful sliding the lid over the wires.
NOT WATERPROOF, just using the PG7 as a strain relief!
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!