ESPixNode Case w/PG7
por PaulTKennedy
9
Descargas
5
Likes
0
Makes
Remixed from hitekstuff's design.
Added nubs to snap the board into.
Swapped orientation of mounting hole.
Added full enclosure and hole for PG7 gland—shared output for DC pigtail and JST-SM connector.
Added graphics to lid.
As shown in pictures, everything is a TIGHT fit—be very careful sliding the lid over the wires.
NOT WATERPROOF, just using the PG7 as a strain relief!
Added nubs to snap the board into.
Swapped orientation of mounting hole.
Added full enclosure and hole for PG7 gland—shared output for DC pigtail and JST-SM connector.
Added graphics to lid.
As shown in pictures, everything is a TIGHT fit—be very careful sliding the lid over the wires.
NOT WATERPROOF, just using the PG7 as a strain relief!
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!