ESPixNode Case w/PG7
di PaulTKennedy
9
Download
5
Likes
0
Makes
Remixed from hitekstuff's design.
Added nubs to snap the board into.
Swapped orientation of mounting hole.
Added full enclosure and hole for PG7 gland—shared output for DC pigtail and JST-SM connector.
Added graphics to lid.
As shown in pictures, everything is a TIGHT fit—be very careful sliding the lid over the wires.
NOT WATERPROOF, just using the PG7 as a strain relief!
Added nubs to snap the board into.
Swapped orientation of mounting hole.
Added full enclosure and hole for PG7 gland—shared output for DC pigtail and JST-SM connector.
Added graphics to lid.
As shown in pictures, everything is a TIGHT fit—be very careful sliding the lid over the wires.
NOT WATERPROOF, just using the PG7 as a strain relief!
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!