Thingiverse
Ork 'ead
von Madpig
3
Downloads
3
Likes
0
Makes
First try with SculptGL
The print came out ok, but it was rather larger than i thought, so i did it at half size.
Printed with support, no sure if that is needed and it leaves a little clean up afterwards
The print came out ok, but it was rather larger than i thought, so i did it at half size.
Printed with support, no sure if that is needed and it leaves a little clean up afterwards
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!