Thingiverse
Ork 'ead
door Madpig
3
Downloads
3
Likes
0
Makes
First try with SculptGL
The print came out ok, but it was rather larger than i thought, so i did it at half size.
Printed with support, no sure if that is needed and it leaves a little clean up afterwards
The print came out ok, but it was rather larger than i thought, so i did it at half size.
Printed with support, no sure if that is needed and it leaves a little clean up afterwards
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!