Thingiverse
Ork 'ead
por Madpig
3
Descargas
3
Likes
0
Makes
First try with SculptGL
The print came out ok, but it was rather larger than i thought, so i did it at half size.
Printed with support, no sure if that is needed and it leaves a little clean up afterwards
The print came out ok, but it was rather larger than i thought, so i did it at half size.
Printed with support, no sure if that is needed and it leaves a little clean up afterwards
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!