Thingiverse
Small case with hinge
von PandaPrecision
30
Downloads
26
Likes
0
Makes
Small case with hinged cap.
You should insert 2mm shaft into the hole of hinge.
Fitting gap was set to 0.2mm.
Sanding would be required when the fitting is tight.
You should insert 2mm shaft into the hole of hinge.
Fitting gap was set to 0.2mm.
Sanding would be required when the fitting is tight.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!