Thingiverse
Small case with hinge
door PandaPrecision
30
Downloads
26
Likes
0
Makes
Small case with hinged cap.
You should insert 2mm shaft into the hole of hinge.
Fitting gap was set to 0.2mm.
Sanding would be required when the fitting is tight.
You should insert 2mm shaft into the hole of hinge.
Fitting gap was set to 0.2mm.
Sanding would be required when the fitting is tight.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!