Thingiverse
Small case with hinge
por PandaPrecision
30
Descargas
26
Likes
0
Makes
Small case with hinged cap.
You should insert 2mm shaft into the hole of hinge.
Fitting gap was set to 0.2mm.
Sanding would be required when the fitting is tight.
You should insert 2mm shaft into the hole of hinge.
Fitting gap was set to 0.2mm.
Sanding would be required when the fitting is tight.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!