Thingiverse
Joystick controller test bracket
von t0b1
31
Downloads
30
Likes
0
Makes
Simple test bracket for two KY-023 joystick modules. More fun than I thought. :)
I used “Hilbert Curve” as the top and bottom infill pattern.
OpenSCAD file is included.
You will need 2 × 4 = 8 M3x10 screws and nuts.
I also recommend to use washers.
I used “Hilbert Curve” as the top and bottom infill pattern.
OpenSCAD file is included.
You will need 2 × 4 = 8 M3x10 screws and nuts.
I also recommend to use washers.
t0b1 veröffentlicht auch auf
85 zusätzliche Modelle auf 2 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
