Thingiverse
Joystick controller test bracket
door t0b1
31
Downloads
30
Likes
0
Makes
Simple test bracket for two KY-023 joystick modules. More fun than I thought. :)
I used “Hilbert Curve” as the top and bottom infill pattern.
OpenSCAD file is included.
You will need 2 × 4 = 8 M3x10 screws and nuts.
I also recommend to use washers.
I used “Hilbert Curve” as the top and bottom infill pattern.
OpenSCAD file is included.
You will need 2 × 4 = 8 M3x10 screws and nuts.
I also recommend to use washers.
t0b1 publiceert ook op
85 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
