Slicer Discord
OBSERVATIONS - NOTES – Modèle 3D imprimable de Thingiverse Thingiverse

OBSERVATIONS - NOTES

par BETLOG
8 Téléchargements
13 Likes
0 Makes
Voir le modèle
Stuff I noticed. You'll need to figure out which image each bullet point refers to. It should be fairly obvious.

- modprobe cp210x
I have a trigorilla 1.3 board that I removed from my i3 becausee I couldn't flash it with new firmware FROM SOURCE due to Anycubic's classic misuse of the Marlin Opensource License. Fast forward several years and now there is reverse engineered source available, and Marlin has trigorilla board pin definitions included... so I have - again - been trying to flash and go back to using it. Problem being that it was unrecognised as a tty/usb device when i plug it into my linux machine. So for the dozenth time I do a bit more googling and happen to notice the 'feature' reference to the serial chip.... googled that...turns out all i need to do is "modprobe cp210x" and suddenly I can flash the board. YAY. Now I can put it's guts back inside the case ...as opposed to being strewn over my desk like the RAMPS has been for the last year+... and use most of the orig
Source
Thingiverse
Ce qu'il faut pour imprimer: Débutant Confiance faible
Monobloc
Supports 1/3
Assemblage 0/3
Réglages 1/3
Taille du plateau 0/3
Post-traitement 0/3
Imprimante
FDM / FFF
Format de fichier
STL
Matériau
Logiciel
Cura, PrusaSlicer ou similaire
Pas encore d'évaluations
Pas encore de commentaires – soyez le premier !
Feed Blog Slicer Calculateur Recherche par image Soumettre Contact Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Ajouter à la collection