Slicer Discord
OBSERVATIONS - NOTES – Modello 3D stampabile da Thingiverse Thingiverse

OBSERVATIONS - NOTES

di BETLOG
8 Download
13 Likes
0 Makes
Vai al Modello
Stuff I noticed. You'll need to figure out which image each bullet point refers to. It should be fairly obvious.

- modprobe cp210x
I have a trigorilla 1.3 board that I removed from my i3 becausee I couldn't flash it with new firmware FROM SOURCE due to Anycubic's classic misuse of the Marlin Opensource License. Fast forward several years and now there is reverse engineered source available, and Marlin has trigorilla board pin definitions included... so I have - again - been trying to flash and go back to using it. Problem being that it was unrecognised as a tty/usb device when i plug it into my linux machine. So for the dozenth time I do a bit more googling and happen to notice the 'feature' reference to the serial chip.... googled that...turns out all i need to do is "modprobe cp210x" and suddenly I can flash the board. YAY. Now I can put it's guts back inside the case ...as opposed to being strewn over my desk like the RAMPS has been for the last year+... and use most of the orig
Fonte
Thingiverse
Cosa serve per stampare: Principiante Bassa affidabilità
Pezzo unico
Supporti 1/3
Assemblaggio 0/3
Impostazioni 1/3
Dimensioni piano 0/3
Post-lavorazione 0/3
Stampante
FDM / FFF
Formato file
STL
Materiale
Software
Cura, PrusaSlicer o simile
Ancora nessuna valutazione
Ancora nessun commento – sii il primo!
Feed Blog Slicer Calcolatore Ricerca per immagine Invia Contatto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Aggiungi alla collezione