Slicer Discord
OBSERVATIONS - NOTES – 3D-printbaar model van Thingiverse Thingiverse

OBSERVATIONS - NOTES

door BETLOG
8 Downloads
13 Likes
0 Makes
Model downloaden
Stuff I noticed. You'll need to figure out which image each bullet point refers to. It should be fairly obvious.

- modprobe cp210x
I have a trigorilla 1.3 board that I removed from my i3 becausee I couldn't flash it with new firmware FROM SOURCE due to Anycubic's classic misuse of the Marlin Opensource License. Fast forward several years and now there is reverse engineered source available, and Marlin has trigorilla board pin definitions included... so I have - again - been trying to flash and go back to using it. Problem being that it was unrecognised as a tty/usb device when i plug it into my linux machine. So for the dozenth time I do a bit more googling and happen to notice the 'feature' reference to the serial chip.... googled that...turns out all i need to do is "modprobe cp210x" and suddenly I can flash the board. YAY. Now I can put it's guts back inside the case ...as opposed to being strewn over my desk like the RAMPS has been for the last year+... and use most of the orig
Bron
Thingiverse
Wat je nodig hebt om te printen: Beginner Lage betrouwbaarheid
Eendelig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 0/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie