Thingiverse
rigidbot e3d cooling setup
por iornman86
0
Descargas
1
Likes
0
Makes
rigidbot e3d cooling setup printed in abs at 40mm/s .35 mm layer height. Uses centrifugal fans to get rid of those horrible little ones
The large fin on the back of the part cooling duct is to aid adhesion, it will snap off easily
The large fin on the back of the part cooling duct is to aid adhesion, it will snap off easily
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!