Thingiverse
rigidbot e3d cooling setup
von iornman86
0
Downloads
1
Likes
0
Makes
rigidbot e3d cooling setup printed in abs at 40mm/s .35 mm layer height. Uses centrifugal fans to get rid of those horrible little ones
The large fin on the back of the part cooling duct is to aid adhesion, it will snap off easily
The large fin on the back of the part cooling duct is to aid adhesion, it will snap off easily
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!