Thingiverse
rigidbot e3d cooling setup
by iornman86
0
Downloads
1
Likes
0
Makes
rigidbot e3d cooling setup printed in abs at 40mm/s .35 mm layer height. Uses centrifugal fans to get rid of those horrible little ones
The large fin on the back of the part cooling duct is to aid adhesion, it will snap off easily
The large fin on the back of the part cooling duct is to aid adhesion, it will snap off easily
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!