Thingiverse
rigidbot e3d cooling setup
door iornman86
0
Downloads
1
Likes
0
Makes
rigidbot e3d cooling setup printed in abs at 40mm/s .35 mm layer height. Uses centrifugal fans to get rid of those horrible little ones
The large fin on the back of the part cooling duct is to aid adhesion, it will snap off easily
The large fin on the back of the part cooling duct is to aid adhesion, it will snap off easily
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!