Thingiverse
rigidbot e3d cooling setup
di iornman86
0
Download
1
Likes
0
Makes
rigidbot e3d cooling setup printed in abs at 40mm/s .35 mm layer height. Uses centrifugal fans to get rid of those horrible little ones
The large fin on the back of the part cooling duct is to aid adhesion, it will snap off easily
The large fin on the back of the part cooling duct is to aid adhesion, it will snap off easily
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!